Dishwasher Repair Near You
Get connected with an independent company that repairs built-in, drawer and portable dishwashers from every major brand.
Dishwasher problems cluster around four parts: the drain pump (standing water), the door latch or control (will not start), the inlet valve (will not fill) and the circulation pump or spray arms (dirty dishes). Most repairs run $150–$350. Leaks are usually a door gasket or a cracked hose and are on the cheaper end. Call with the brand and symptom; the company confirms its diagnostic fee and a visit time.
What's wrong with your dishwasher? Common problems and typical repair cost
Every symptom below is a job the company you're connected with sees every week. Prices are typical US ranges for parts plus labor — the exact figure depends on your model and is quoted before any work starts.
| Dishwasher symptom | Usual cause | Typical cost |
|---|---|---|
| Not draining / water in bottom | Drain pump, clogged filter, air gap or drain hose, check valve | $120 – $300 |
| Leaking from door or underneath | Door gasket, spray arm, float switch, hose, pump seal | $120 – $350 |
| Dishes come out dirty or gritty | Circulation pump, clogged spray arms, filter, inlet valve | $150 – $350 |
| Will not start / no lights | Door latch, control board, thermal fuse, wiring | $120 – $400 |
| Not filling with water | Water inlet valve, float switch, door switch | $120 – $280 |
| Not drying / no heat | Heating element, high-limit thermostat, vent fan | $150 – $300 |
| Stops mid-cycle / error code | Control board, drain issue, door latch, sensor | $150 – $400 |
How dishwasher repair works when you call
Brand, type of dishwasher, and the symptom — takes about two minutes.
We connect you with an independent repair company that covers your ZIP code and can take the job.
The company confirms its visit fee, diagnoses the dishwasher, quotes the repair and — if you approve — usually completes it the same visit when the part is on the truck.
What to have ready before you call
- The brand and model number (usually on a sticker inside the door or on the back)
- The symptom in plain words — what it does, what it does not do, any error code on the display
- Roughly how old the dishwasher is (helps the company advise repair vs. replace honestly)
- Whether it is still under manufacturer warranty — if so, contact the manufacturer first
Brands the companies commonly repair
Independent repair for Bosch, KitchenAid, Whirlpool, GE, Samsung, LG, Frigidaire, Maytag and Miele — and most other household brands. Brand names are used for identification only; the companies are independent and not affiliated with the manufacturers. Premium and built-in models are often handled by specialists, so name the brand when you call.
Repair or replace your dishwasher?
Dishwashers last about 9–12 years. Control-board plus pump failures on a unit over 9 years old usually justify replacement; single-part repairs almost never do. The common rule: repair if the quote is under half the price of a comparable new unit and the appliance is not near the end of its typical lifespan. Use the repair-or-replace calculator for a quick answer on your specific case.
Common questions
Water is standing in the bottom after every cycle — what is wrong?
Most often the filter or drain pump is blocked, or the drain hose/air gap is clogged. If a garbage disposal was installed recently, the knockout plug may not have been removed — a common cause the company can spot in minutes.
Bosch dishwasher stopped mid-cycle with an error code — repairable?
Yes. Error codes point to drain, fill, heating or door faults; the company reads the code and replaces the failed part. Bring the code up when you call.
Do they handle built-in panel-ready dishwashers?
Yes — mention it is integrated or panel-ready so the visit is planned for cabinet removal.
Under warranty?
Warranty repairs go through the manufacturer. We connect you with independent companies for out-of-warranty work.
Published 2026-09-22 · Updated 2026-09-22